On Sun, Mar 04, 2012 at 09:34:05PM +0530, Mayuresh wrote: > 1. Shall I use make print-PLIST to generate a new PLIST or there is any > other manual method to be followed? PS: I used print-PLIST method and the output looked "reasonably correct" to me and the install worked, too. But I am not sure what exactly one should watch for to ensure PLIST is correct. > > 2. After tweaking PLIST, do I have to run make clean and build again and > then install? Can't I just make install target refer to new PLIST? That's really painful. You have a build and a new PLIST, why do you have to clean the build and start all over again? Hope there is a short cut. Mayuresh.