Isotopes of cobalt

One of the terminal nuclear reactions in stars prior to supernova produces ⁵⁶Ni. Following its production, ⁵⁶Ni decays to ⁵⁶Co, and then ⁵⁶Co subsequently decays to ⁵⁶Fe. These decay reactions power the luminosity displayed in light decay curves. Both the light decay and radioactive decay curves are expected to be exponential. Therefore, the light decay curve should give an indication of the nuclear reactions powering it. This has been confirmed by observation of bolometric light decay curves for SN 1987A. Between 600 and 800 days after SN1987A occurred, the bolometric light curve decreased at an exponential rate with half-life values from τ_1/2 = 68.6 days to τ_1/2 = 69.6 days.^[5] The rate at which the luminosity decreased closely matched the exponential decay of ⁵⁶Co with a half-life of τ_1/2 = 77.233 days.

Cobalt-57 (⁵⁷Co or Co-57) is used in medical tests; it is used as a radiolabel for vitamin B₁₂ uptake. It is useful for the Schilling test.^[6]

Cobalt-60 (⁶⁰Co or Co-60) is used in radiotherapy. It produces two gamma rays with energies of 1.17 MeV and 1.33 MeV. The ⁶⁰Co source is about 2 cm in diameter and as a result produces a geometric penumbra, making the edge of the radiation field fuzzy. The metal has the unfortunate habit of producing fine dust, causing problems with radiation protection. The ⁶⁰Co source is useful for about 5 years but even after this point is still very radioactive, and so cobalt machines have fallen from favor in the Western world where Linacs are common.

Cobalt-60 (⁶⁰Co) is useful as a gamma ray source because it can be produced in predictable quantities, and for its high radioactivity simply by exposing natural cobalt to neutrons in a reactor.^[7] The uses for industrial cobalt include:

• Sterilization of medical supplies and medical waste
• Radiation treatment of foods for sterilization (cold pasteurization)^[8]
• Industrial radiography (e.g., weld integrity radiographs)
• Density measurements (e.g., concrete density measurements)
• Tank fill height switches

⁵⁷Co is used as a source in Mössbauer spectroscopy of iron-containing samples. Electron capture by ⁵⁷Co forms an excited state of the ⁵⁷Fe nucleus, which in turn decays to the ground state with the emission of a gamma ray. Measurement of the gamma-ray spectrum provides information about the chemical state of the iron atom in the sample.

• Isotope masses from:
  • Audi, Georges; Bersillon, Olivier; Blachot, Jean; Wapstra, Aaldert Hendrik (2003), "The NUBASE evaluation of nuclear and decay properties", Nuclear Physics A, 729: 3–128, Bibcode:2003NuPhA.729....3A, doi:10.1016/j.nuclphysa.2003.11.001
• Half-life, spin, and isomer data selected from the following sources.
  • Audi, Georges; Bersillon, Olivier; Blachot, Jean; Wapstra, Aaldert Hendrik (2003), "The NUBASE evaluation of nuclear and decay properties", Nuclear Physics A, 729: 3–128, Bibcode:2003NuPhA.729....3A, doi:10.1016/j.nuclphysa.2003.11.001
  • National Nuclear Data Center. "NuDat 2.x database". Brookhaven National Laboratory.
  • Holden, Norman E. (2004). "11. Table of the Isotopes". In Lide, David R. (ed.). CRC Handbook of Chemistry and Physics (85th ed.). Boca Raton, Florida: CRC Press. ISBN 978-0-8493-0485-9.