Contents

Snaffle bit

Asnaffle bit is the most common type of bit used while riding horses. It consists of a bit mouthpiece with a ring on each side and acts with direct pressure. A bridle utilizing only a snaffle bit is often called a "snaffle bridle", particularly in the English riding disciplines. A bridle that carries two bits, a curb bit and a snaffle, or "bradoon", is called a double bridle.

A snaffle is not necessarily a bit with a jointed bit mouthpiece, as is often thought. A bit is a snaffle because it creates direct pressure without leverage on the mouth. It is a bit without a shank. Therefore, a single- or double-jointed mouthpiece, though the most common designs for snaffle bits, does not make a bit a snaffle. Even a mullen mouth (a solid, slightly curved bar) or a bar bit is a snaffle.

The snaffle bit works on several parts of the horse's mouth; the mouthpiece of the bit acts on the tongue and bars, the lips of the horse also feel pressure from both the mouthpiece and the rings. The rings also serve to act on the side of the mouth, and, depending on design, the sides of the jawbone.^[1]

A snaffle is sometimes mistakenly thought of as "any mild bit". While direct pressure without leverage is milder than pressure with leverage, nonetheless, certain types of snaffle bits can be extremely harsh when manufactured with wire, twisted metal or other "sharp" elements. A thin or rough-surfaced snaffle, used harshly, can damage a horse's mouth.^[2]

Curb chains or straps have no effect on a true snaffle because there is no leverage to act upon. English riders do not add any type of curb strap or curb chain to a snaffle bit. While some riders in western disciplines do add a curb strap to the rings, it is merely a "hobble" for the rings, has no leverage effect and is there only as a safety feature to prevent the rings from being pulled through the mouth of the horse, should the animal gape open its mouth in an attempt to avoid the bit, an outcome prevented in an English bridle by the presence of a cavesson noseband.

The snaffle differs from the pelham bit, the curb bit, and the kimberwicke in that it is a non-leverage bit, and so does not amplify the pressure applied by the reins. With a snaffle, one ounce of pressure applied by the reins to a snaffle mouthpiece will apply one ounce of pressure on the mouth. With a curb, one ounce of pressure on the reins will apply more – sometimes far more – than one ounce of pressure on the horse's mouth.^[2]

There are many riders (and a remarkable number of tack shops) who do not know the true definition of a snaffle: a bit that is non-leverage. This often results in a rider purchasing a jointed mouthpiece bit with shanks, because it is labeled a "snaffle," and believing that it is soft and kind because of the connotation the snaffle name has with being mild. In truth, the rider actually bought a curb bit with a jointed mouthpiece, which actually is a fairly severe bit due to the combination of a nutcracker effect on the jaw and leverage from the shanks.

A true snaffle does not have a shank like a pelham or curb bit. Although the kimberwicke appears to have a D-shaped bit ring like a snaffle, the bit mouthpiece is not centered on the ring, and thus applying the reins creates leverage; in the Uxeter kimberwicke, there are slots for the reins placed within the bit ring, which allows the reins to create additional leverage. Both are used with a curb chain, thus the ring acts like a bit shank and creates a slight amount of leverage, making it a type of curb bit.

A true snaffle also will not be able to slide up and down the rings of the bit or cheekpieces of the bridle, as this would place it in the gag bit category.

The mouthpiece is the more important part of a snaffle, as it controls the severity of the bit. Thinner mouthpieces are more severe, as are those that are rougher.

• Jointed mouthpiece: applies pressure to the tongue, lips, and bars with a "nutcracker" action. This is the most common mouthpiece found on a snaffle.^[3]
• Mullen mouth: made of hard rubber or a half-moon of metal, it places even pressure on the mouthpiece, lips, and bars. It is a very mild mouthpiece.^[3]
• French mouth: a double-jointed mouthpiece with a bone-shaped link in the middle. It reduces the nutcracker action and encourages the horse to relax. Very mild.
• Dr. Bristol: a double-jointed mouthpiece with a thin rectangular link in the middle that is set at an angle, creating a pressure point. It is a fairly severe bit. The French link is similar but much gentler because the link in the middle is flat against the tongue, lips, and bar and has no pressure points. Neither the Dr. Bristol nor the French Link nutcracker, but their severity is totally opposite.
• Slow twist: a single-jointed mouthpiece with a slight twist in it. Stronger and more severe.
• Corkscrew: Many small edges amplifies the pressure on the mouth. Severe.
• Single- and double-twisted wire: two of the most severe mouthpieces, as they are not only thin, but they also have a "nutcracker" action from the single joint and the mouthpiece concentrates pressure due to its severe twisting.^[4]
• Roller mouthpieces: tend to make horses relax their mouth and activate the tongue, encouraging salivation and acceptance of the bit. This may also focus tense or nervous horses to the bit.^[4]
• Hollow mouth: usually single-jointed with a thick, hollow mouthpiece which spreads out the pressure and makes the bit less severe. May not fit comfortably in some horses' mouths if they are a little small.

There are several types of rings that affect the action of the bit.

• Loose ring: slides through the mouthpiece. Tends to make the horse relax his jaw and chew the bit. May pinch the corners of the horse's mouth if the holes in the mouthpiece are large, in which case a bit guard should be used.^[5]
• Egg butt/barrel head: mouthpiece does not rotate, and is so more fixed in the horse's mouth, which some horses prefer. Will not pinch the lips.^[6][7]
• D-ring/ racing snaffle: ring in the shape of a "D" which does not allow the bit to rotate and so the bit is more fixed. The sides of the D provide a lateral guiding effect.^[6]
• Full cheek: has long, extended arms above and below the mouthpiece on either side of the lips of the horse, with a ring attached to it. The cheeks have a lateral guiding effect, and also prevent the bit from sliding through the mouth. The full cheek is often used with bit keepers to prevent the cheeks from getting caught on anything, and to keep the bit in the right position inside the mouth.^[5][6]
• Half-cheek: has only an upper or, more commonly, lower cheek, as opposed to both seen in a full cheek snaffle. Often used in racing, as there is less chance of the cheek being caught on the starting gate, or in driving as there is less chance of getting caught on harness straps.
• Baucher (hanging cheek): has a ring on the side of the mouthpiece, with a smaller ring above to attach the cheekpiece of the bridle. Tends to concentrate pressure on the bars. It is very fixed in the mouth.
• Fulmer: a full cheek bit with a loose ring attached, so that it not only has the lateral guiding effect, but can also move freely as with a loose ring.^[6]

• Bridle
• Horse tack
• National Snaffle Bit Association
• National Snaffle Bit Association Hall of Fame

Edwards Complete Book of Bits and Bitting pp. 52–54 Kapitzke Bit and Reins p. 79 Edwards Complete Book of Bits and Bitting p. 55 Edwards Complete Book of Bits and Bitting p. 68 Edwards Complete Book of Bits and Bitting p. 57 Edwards Complete Book of Bits and Bitting p. 58 Kapitzke Bit and Reins p. 95

• Edwards, Elwyn Hartley (2004). The Complete Book of Bits & Bitting. Newton Abbot, Devon: David & Charles Publishers. ISBN 978-0-7153-1163-9.
• Kapitzke, Gerhard (2004). The Bit and the Reins: Developing Good Contact and Sensitive Hands. North Pomfret, VT: Trafalgar Square Publishing. ISBN 978-1-57076-275-8.
• Dr. Hilary Clayton Offers Many Prescriptions For Bits
• A fluoroscopic study of the position and action of the jointed snaffle bit in the horse's mouth