| vz. 58 | |
|---|---|
The vz. 58 P (with stock, pistol grip, and handguards; and sling).
| |
| Type | Assault rifle |
| Place of origin | Czechoslovakia |
| Service history | |
| In service | 1959–present |
| Used by | See Users |
| Wars |
|
| Production history | |
| Designer | Jiří Čermák |
| Designed | 1956–1958 |
| Manufacturer | Česká zbrojovka Uherský Brod |
| Produced | 1959–1984 |
| No. built | Approx. 920,000 |
| Variants | See Variants |
| Specifications | |
| Mass | 2.91 kg (6.42 lb) |
| Length |
|
| Barrel length | 390 mm (15.4 in) |
| Width |
|
| Height | 255 mm (10.0 in) |
| Cartridge | 7.62×39mm |
| Action | Gas-operated, hinged locking piece assisted breechblock |
| Rate of fire | 800 rounds/min |
| Muzzle velocity | 705 m/s (2,313 ft/s) Muzzle energy: 1988 J |
| Effective firing range | 100–800 m sight adjustments |
| Maximum firing range | 2,800 m |
| Feed system | Staggered 30-round detachable box magazine, weight 0.19 kg (0.42 lb) unloaded |
| Sights | Open-type iron sights with sliding rear tangent and shrouded front post 353 mm (13.9 in) sight radius |
The vz. 58 (orSa vz. 58) is a 7.62×39mm assault rifle designed and manufactured in Czechoslovakia and accepted into service in the late 1950s as the 7,62 mm samopal vzor 58, replacing the vz. 52 self-loading rifle and the 7.62×25mm Tokarev Sa 24 and Sa 26 submachine guns.
While externally the vz. 58 resembles the Soviet AK-47, it is a different design based on a short-stroke gas piston. The only component that it shares with Kalashnikov rifles is the ammunition.
 |
This section needs to be updated. Please help update this article to reflect recent events or newly available information. (December 2023)
|
Development of the weapon began in 1956; leading the project was chief engineer Jiří Čermák assigned to the Konstrukta Brno facility in the city of Brno. The Soviet Union had begun insisting that the Warsaw Pact forces standardize on a common ammunition. As a result, the prototype, known as the『Koště』("broom"), was designed to chamber the intermediate Soviet 7.62×39mm M43 cartridge, rather than the Czech 7.62×45mm vz. 52 round, used in both the earlier vz. 52 rifle and the vz. 52 light machine gun.[7] The assault rifle entered service in 1958 and over a period of 25 years (until 1984), over 920,000 weapons had been produced, fielded by the armed forces of Czechoslovakia, Cuba and several Asian and African nations.
The vz. 58 was produced in three main variants: the standard vz. 58 P (Pěchotní or "infantry") model with a fixed buttstock made of a synthetic material (plastic impregnated wood, older versions used a wooden stock), the vz. 58 V (Výsadkový—"airborne"), featuring a side-folding metal shoulder stock, folded to the right side, and the vz. 58 Pi (Pěchotní s infračerveným zaměřovačem—"infantry with infrared sight"), which is similar to the vz. 58 P but includes a receiver-mounted dovetail rail bracket (installed on the left side of the receiver) used to attach an NSP2 night sight; it also has a detachable folding bipod and an enlarged conical flash suppressor. For the first two variants, the two types of stock are interchangeable and mount to the same mounting point on the rifle itself, which is identical in either variant.
A successor to the vz. 58 was proposed in the 1990s; the 5.56×45mm NATO ČZ 2000 assault rifle has been suggested as a possible replacement but due to a general lack of defense funds within the Czech Republic, the program was postponed. Another recent contender is the ČZW-556 assault rifle and ČZW-762 light machine gun which both use lever-delayed blowback which has more reliable accuracy and performance over the gas operation. In 2011, the Czech army started replacing vz. 58 with CZ-805 BREN. While vz. 58 still remains the main assault rifle of the Slovak army, the Slovak army has also been eyeing CZ-805 as a possible replacement to the aging vz. 58 rifles.
 |
This section relies largely or entirely upon a single source. Relevant discussion may be found on the talk page. Please help improve this article by introducing citations to additional sources at this section. (July 2021) (Learn how and when to remove this message)
|
The vz. 58 is a selective fire gas-operated weapon that bleeds expanding combustion gases generated in the barrel from the ignited cartridge through a port drilled in the barrel, 215 mm (8.5 in) from the chamber, opening into a hollow cylinder located above the barrel that contains a short-stroke piston. The vz. 58 does not have a gas regulator and the full force of the gas pressure is exerted on the piston head, propelling it backwards in a single impulsive blow. The piston is driven back only 19 mm (0.7 in) when a shoulder on the piston rod butts against the seating and no further movement is possible. There is a light return spring held between the piston shoulder and the seating which returns the piston to its forward position. The gas cylinder is vented after the piston has traveled back 16 mm (0.6 in) and the remaining gases are exhausted into the atmosphere on the underside of the cylinder via two ports. The entire piston rod is chromium-plated to prevent fouling.
The locking system features a locking piece hinged from the bolt and housed in the bolt carrier that contains two locking lugs which descend into and engage locking shoulders in the receiver's internal guide rails. The weapon is unlocked by the short tappet-like stroke of the piston rod as it strikes the bolt carrier and drives it rearwards. After 22 mm (0.9 in) of unrestricted travel, a wedge-like surface on the bolt carrier moves under the hinged breech locking piece and lifts it up and out of engagement with the locking recesses in the steel body. The hinged breech locking piece swings up and this movement provides the leverage required for primary extraction. The breech block is then carried rearwards extracting the empty cartridge casing from the chamber. A fixed ejector passes through a groove cut in the underside of the bolt and the case is flung upwards clear of the gun.
The spring-loaded extractor and firing pin are both housed inside the bolt, while the fixed ejector is slotted inside the receiver. The extractor retains the firing pin and is powered by its own plunger and spring.
The weapon does not have a conventional rotating hammer but a linear hammer instead. The hammer is a steel cylinder hollowed from one end almost throughout its entire length to accommodate its own operating spring. At the open end of the cylinder, a plate is welded and a groove is cut in each side of this to slide on the receiver guide rails. This linear hammer enters the hollow bolt and drives a free-floating firing pin forward with each shot.[7]
The vz.58 uses a trigger mechanism with a lever-type fire mode selector, which is also a manual safety against accidental discharge. When the selector lever is placed in its rear position ("1"—single fire) the sear is disabled and the left hammer catch is rotated by the disconnector, which is depressed by the bolt carrier after every shot and is therefore disconnected from the hammer catch. The forward setting of the selector lever ("30"—automatic fire) disables the disconnector, and the left hammer catch meshes with the sear mechanism. The center ("safe") setting with the selector lever pointing vertically downwards, mechanically lowers the trigger bar and the disconnector so there is no connection between the trigger and the semi-automatic sear which holds the hammer. The rifle also has an internal safety, which prevents the weapon from discharging when out of battery. The right linear hammer catch disables it, and it can only be released by pulling the charging handle back and cocking the weapon.
The weapon is fed from a detachable box magazine with a 30-round cartridge capacity and made from a lightweight aluminium alloy.[7] When the last round from the magazine is fired, the bolt will remain locked open on the bolt catch, activated by the magazine's follower. The magazine release tab is located at the base of the receiver on the left side, behind the magazine well. The bolt carrier has a built-in guide rail used for reloading from 10-round stripper clips (from the SKS rifle). Despite their similarity, vz. 58 magazines are not interchangeable with those of the Kalashnikov-pattern weapons.
An interesting feature on this rifle is the ability to quickly change the type of stock. The vz. 58 can appear either with its original fixed stock (in either beech wood or composite material) or folding steel stock, or with one of the many aftermarket stocks available – including AR-15 style stock adapters that mount a buffer tube to the receiver. The latter usually has the buffer tube slightly angled down as to compensate for the very low ironsights on the vz. 58. Switching between the various options requires merely removal of a bolt at the rear of the receiver and swapping in the stock of choice.
The rifle's iron sights consist of a fully adjustable front post and a tangent rear sight with a sliding notch with range denominations from 100 to 800 m, graduated every 100 m. Besides this, the left side of the rear sight leaf is marked with the letter "U" (univerzální meaning "universal"), for snap shooting, firing at moving targets and night combat at ranges up to 300 m. The rifle's sight radius is 15 inches (38 cm).[7] The front sight base also serves as a mounting platform for the vz. 58 edged bayonet.
Several modernization accessories have been manufactured for the vz. 58 platform from different companies. Accessories include "tactical" bolt release, extended and/or ambidextrous magazine release paddles, ambidextrous fire mode selectors, custom handguard rails, several types of sight mounting options and various muzzle brakes and compensators. Both civilian and military users use these upgrades, and they also see frequent use with private military companies in the Middle East.
Additional equipment supplied with the rifle includes: 4 spare magazines, a magazine pouch (in either canvas, leather, or leatherette), vz. 58 bayonet and scabbard, cleaning brush and rod, muzzle cap, oil bottle, unified sling, front sight adjustment tool, disassembly aid and a threaded blank-firing adaptor. The vz. 58 also has a proprietary bipod, flash hider and scope mount for NSP-2 night vision scope (vz.58 P variant). Grenade launching inserts, as well as under barrel grenade launchers were developed but never adopted.
|
This section relies largely or entirely upon a single source. Relevant discussion may be found on the talk page. Please help improve this article by introducing citations to additional sources at this section. (February 2022) (Learn how and when to remove this message)
|
Angola[10]
Biafra:[11] 732[12]
Burundi: Burundian rebels[13]
Cuba[14]
Cyprus[14][15]
Eritrea[14]
Ethiopia[14]
Guatemala[10]
Guinea[14]
India[10]
Indonesia[16]
Iraq[10]
Kurdistan[17]
Ivory Coast[18]
Libya[14]
Mozambique[14]
PhilippinesBureau of Corrections[19]
Slovakia:[14] Standard service rifle.
Somalia[14]
Syria[14]
Tanzania[14]
Ukraine: 5,000 Vz. 58s were donated by the Czech Republic.[6]
Vietnam[20]
Afghanistan (2009-20)[14]
Czech Republic: Standard service rifle 1959 - 2011[14][21][22] replaced by CZ BREN 2.[23]
United States: Some captured rifles used by LRRPs in Vietnam[24]
Democratic Forces for the Liberation of Rwanda[25]
Islamic State[26]
Northern Irish loyalist paramilitaries[27]
New People's Army[2] Peshmerga[28]
South Sudan Democratic Movement[29]
