Calcium silicate can refer to several silicates of calcium including:
| |
| Names | |
|---|---|
| Preferred IUPAC name
Calcium silicate | |
| Systematic IUPAC name
Dicalcium silicate | |
Other names
| |
| Identifiers | |
 YY | |
3D model (JSmol) |
|
| ChEBI | |
| ChemSpider |
Y |
| ECHA InfoCard | 100.014.282 
|
| EC Number |
|
| E number | E552 (acidity regulators, ...) |
| KEGG |
|
| MeSH | Calcium+silicate |
PubChem CID |
|
| UNII |
Y |
CompTox Dashboard (EPA) |
|
| |
| |
| Properties | |
| Ca2O4Si | |
| Molar mass | 172.237 g·mol−1 |
| Appearance | White crystals |
| Density | 2.9 g/cm3 (solid)[1] |
| Melting point | 2,130[2] °C (3,870 °F; 2,400 K) |
| 0.01% (20 °C)[1] | |
| Thermochemistry | |
Std molar |
84 J/(mol·K)[3] |
Std enthalpy of |
−1630 kJ/mol[3] |
| Pharmacology | |
| A02AC02 (WHO) | |
| Hazards | |
| Occupational safety and health (OHS/OSH): | |
Main hazards |
Irritant |
| NFPA 704 (fire diamond) | |
| Flash point | Not applicable |
| NIOSH (US health exposure limits): | |
PEL (Permissible) |
TWA 15 mg/m3 (total) TWA 5 mg/m3 (resp)[1] |
REL (Recommended) |
TWA 10 mg/m3 (total) TWA 5 mg/m3 (resp)[1] |
IDLH (Immediate danger) |
N.D.[1] |
| Safety data sheet (SDS) | [4] |
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa). | |
This article focuses on Ca2SiO4, also known as calcium orthosilicate. It is also referred to by the shortened trade name Cal-Sil or Calsil. All calcium silicates are white free-flowing powders. They are components of important structural materials because they are strong, cheap, and nontoxic.
Calcium silicates are produced by treating calcium oxide and silica in various ratios. Their formation is relevant to Portland cement.[5]
Calcium silicate is a byproduct of the Pidgeon process, a major route to magnesium metal. The process converts a mixture of magnesium and calcium oxides as represented by the following simplified equation:[6]
The calcium oxide combines with silicon as the oxygen scavenger, yielding the very stable calcium silicate and releasing volatile (at high temperatures) magnesium metal.
Via the carbonate–silicate cycle, carbonate rocks convert into silicate rocks by metamorphism and volcanism and silicate rocks convert to carbonatesbyweathering and sedimentation.[7][8]
The production of sulfuric acid from anhydrous calcium sulfate produces calcium silicates.[9] Upon being mixed with shaleormarl, and roasted at 1400 °C, the sulfate liberates sulfur dioxide gas, a precursor to sulfuric acid. The resulting calcium silicate is used in cement clinker production.[10]
As verified by X-ray crystallography, calcium silicate is a dense solid consisting of tetrahedral orthosilicate (SiO44-) units linked to Ca2+ via Si-O-Ca bridges. There are two calcium sites. One is seven coordinate and the other is eight coordinate.[11]
Calcium silicates are the major ingredients in Portland cements.[12]
| Clinker | CCN | Mass | Mineral |
|---|---|---|---|
| Tricalcium silicate (CaO)3 · SiO2 | C3S | 25–50% | alite |
| Dicalcium silicate (this article) (CaO)2 · SiO2 | C2S | 20–45% | belite]] |
| Tricalcium aluminate (CaO)3 · Al2O3 | C3A | 5–12% | |
| Tetracalcium aluminoferrite (CaO)4 · Al2O3 · Fe2O3 | C4AF | 6–12% | |
| CaSO4 · 2 H2O | CS̅H2 | 2–10% | gypsum |
Calcium silicate is commonly used as a safe alternative to asbestos for high-temperature insulation materials. Industrial-grade piping and equipment insulation is often fabricated from calcium silicate. Its fabrication is a routine part of the curriculum for insulation apprentices. Calcium silicate competes in these realms against rockwool and proprietary insulation solids, such as perlite mixture and vermiculite bonded with sodium silicate. Although it is popularly considered an asbestos substitute, early uses of calcium silicate for insulation still made use of asbestos fibers.
It is used in passive fire protection and fireproofingascalcium silicate brick or in roof tiles. It is one of the most successful materials in fireproofinginEurope because of regulations and fire safety guidelines for commercial and residential building codes. Where North Americans use spray fireproofing plasters, Europeans are more likely to use cladding made of calcium silicate. [why?] High-performance calcium-silicate boards retain their excellent dimensional stability even in damp and humid conditions and can be installed at an early stage in the construction program, before wet trades are completed and the building is weather-tight. For sub-standard products, silicone-treated sheets are available to fabricators to mitigate potential harm from high humidity or general presence of water. Fabricators and installers of calcium silicate in passive fire protection often also install firestops.[citation needed]
While the best possible reaction to fire classifications are A1 (construction applications) and A1Fl (flooring applications) respectively, both of which mean "non-combustible" according to EN 13501-1: 2007, as classified by a notified laboratory in Europe, some calcium-silicate boards only come with fire classification of A2 (limited combustibility) or even lower classifications (or no classification), if they are tested at all.[citation needed]
Calcium silicate, also known as slag, is produced when molten iron is made from iron ore, silicon dioxide and calcium carbonate in a blast furnace. When this material is processed into a highly refined, re-purposed calcium silicate aggregate, it is used in the remediation of acid mine drainage (AMD) on active and passive mine sites.[13] Calcium silicate neutralizes active acidity in AMD systems by removing free hydrogen ions from the bulk solution, thereby increasing pH. As its silicate anion captures H+ ions (raising the pH), it forms monosilicic acid (H4SiO4), a neutral solute. Monosilicic acid remains in the bulk solution to play other important roles in correcting the adverse effects of acidic conditions. As opposed to limestone (a popular remediation material),[14] calcium silicate effectively precipitates heavy metals and does not armor over, prolonging its effectiveness in AMD systems.[13][15]
It is used as a sealant in roads or on the shells of fresh eggs: when sodium silicate is applied as a sealant to cured concrete or egg shells, it chemically reacts with calcium hydroxideorcalcium carbonate to form calcium silicate hydrate, sealing micropores with a relatively impermeable material.[16][17]
Calcium silicate is often used in agriculture as a plant available source of silicon. It is "applied extensively to Everglades mucks and associated sands planted to sugarcane and rice" [18]
Calcium silicate is used as an anticaking agent in food preparation, including table salt[19] and as an antacid. It is approved by the United Nations' FAO and WHO bodies as a safe food additive in a large variety of products.[20] It has the E number reference E552.
