The Nyquist frequency, named after electronic engineer Harry Nyquist, is half of the sampling rate of a discrete signal processing system.[1][2] It is sometimes known as the folding frequency of a sampling system.[3]
The Nyquist frequency should not be confused with the Nyquist rate, the latter is the minimum sampling rate that satisfies the Nyquist sampling criterion for a given signal or family of signals. The Nyquist rate is twice the maximum component frequency of the function being sampled. For example, the Nyquist rate for the sinusoid at 0.6 fs is 1.2 fs, which means that at the fs rate, it is being undersampled. Thus, Nyquist rate is a property of a continuous-time signal, whereas Nyquist frequency is a property of a discrete-time system.[4][5]
When the function domain is time, sample rates are usually expressed in samples per second, and the unit of Nyquist frequency is cycles per second (hertz). When the function domain is distance, as in an image sampling system, the sample rate might be dots per inch and the corresponding Nyquist frequency would be in cycles/inch.
Continuing on the example given above, undersampling of the aforementioned sinusoid at 0.6 fs is what allows there to be a lower-frequency alias, which is a different function that produces the same set of samples. That condition is usually described as aliasing. The mathematical algorithms that are typically used to recreate a continuous function from its samples will misinterpret the contributions of undersampled frequency components, which causes distortion. Samples of a pure 0.6 fs sinusoid would produce a 0.4 fs sinusoid instead. If the true frequency was 0.4 fs, there would still be aliases at 0.6, 1.4, 1.6, etc.,[note 2] but the reconstructed frequency would be correct.
In a typical application of sampling, one first chooses the highest frequency to be preserved and recreated, based on the expected content (voice, music, etc.) and desired fidelity. Then one inserts an anti-aliasing filter ahead of the sampler. Its job is to attenuate the frequencies above that limit. Finally, based on the characteristics of the filter, one chooses a sample-rate (and corresponding Nyquist frequency) that will provide an acceptably small amount of aliasing.
In applications where the sample-rate is pre-determined, the filter is chosen based on the Nyquist frequency, rather than vice versa. For example, audio CDs have a sampling rate of 44100 samples/sec. The Nyquist frequency is therefore 22050 Hz. The anti-aliasing filter must adequately suppress any higher frequencies but negligibly affect the frequencies within the human hearing range. A filter that preserves 0–20 kHz is more than adequate for that.
Early uses of the term Nyquist frequency, such as those cited above, are all consistent with the definition presented in this article. Some later publications, including some respectable textbooks, call twice the signal bandwidth the Nyquist frequency;[6][7] this is a distinctly minority usage, and the frequency at twice the signal bandwidth is otherwise commonly referred to as the Nyquist rate.
The Nyquist frequency is that frequency whose period is two sampling intervals.
the existence of power in the continuous signal spectrum at frequencies higher than the Nyquist frequency is the cause of aliasing error
Frequencies "fold" around half the sampling frequency - which is why [the Nyquist] frequency is often referred to as the folding frequency.
{{cite book}}: Unknown parameter |lastauthoramp= ignored (|name-list-style= suggested) (help)
The Nyquist rate is twice the bandwidth of the signal ... The Nyquist frequencyorfolding frequency is half the sampling rate and corresponds to the highest frequency which a sampled data system can reproduce without error.
{{cite book}}: CS1 maint: multiple names: authors list (link)
|
| |
|---|---|
| Theory |
|
| Sub-fields |
|
| Techniques |
|
| Sampling |
|
