The G5RV antenna is a dipole with a symmetric resonant[1] feeder line, which serves as impedance matcher for a 50 Ω coax cable to the transceiver.[2][3]
Louis Varney (G5RV) invented this antenna in 1946.[4] It is very popular in the United States.[5] The antenna can be erected as horizontal dipole, as sloper, or an inverted-V antenna. With a transmatch, (antenna tuner) it can operate on all HF amateur radio bands (3.5–30 MHz).[5][6]
The dipole elements are 15.55 metres (51.0 ft) and the impedance-matching symmetric feedline (ladder-line or twin-lead) can be either 300 Ω (8.84 metres or 29.0 feet) or 450 Ω (10.36 metres or 34.0 feet).[7] As is in general the case for all electric antennas, the height of the G5RV above the ground should be at least half of the longest wavelength to be used.[1]
The ends of the symmetric feedline can be soldered directly onto a 50 Ω coax cable to the transceiver,[2] however this is not good practice and should be avoided: It can result in high current flow on the outer surface of the coax braid, causing RF interference and degrading the polarization and gain of the antenna. In his article, Varney recommended placing a balanced matching network at the end of the ladder line, instead of a direct cable connection. With no matching unit, Varney specified 75 Ω cable be used at the junction of the ladder line and coax (not 50 Ω); the higher 75 Ω impedance makes a closer match the end of the ladder line. An earth-grounded 4:1 voltage balun may be used to connect the coax to the ladder line, and 1:1 current balun should be used between the coax and the transmitter.[8] Several sources point out that a current balun not only prevents RF interference, but also reduces receive noise.[9][better source needed] A length of at least 20 metres (66 ft) of 75 Ω (50 Ω) cable is recommended for operation without a balun.[10][11]
Atransmatch (antenna tuner) is not required to use this antenna near its nominal design frequency of 14 MHz, and judicious length adjustments can sometimes include one other frequency band. All other frequencies require a transmatch.[citation needed] There are many variants of the G5RV antenna. Two variations of the G5RV design, called ZS6BKW and W0BTU, can match several more amateur bands between 3.5–28 MHz without a transmatch.[12][13]
{{cite web}}: CS1 maint: numeric names: authors list (link)
{{cite web}}: CS1 maint: numeric names: authors list (link)
{{cite web}}: CS1 maint: numeric names: authors list (link)
 | This article related to radio communications is a stub. You can help Wikipedia by expanding it. |
