then s is called a scale parameter, since its value determines the "scale" or statistical dispersion of the probability distribution. If s is large, then the distribution will be more spread out; if s is small then it will be more concentrated.
If the probability density exists for all values of the complete parameter set, then the density (as a function of the scale parameter only) satisfies
where f is the density of a standardized version of the density, i.e. .
Anestimator of a scale parameter is called an estimator of scale.
In the case where a parametrized family has a location parameter, a slightly different definition is often used as follows. If we denote the location parameter by , and the scale parameter by , then we require that where is the cmd for the parametrized family.[1] This modification is necessary in order for the standard deviation of a non-central Gaussian to be a scale parameter, since otherwise the mean would change when we rescale . However, this alternative definition is not consistently used.[2]
Some families of distributions use a rate parameter (or "inverse scale parameter"), which is simply the reciprocal of the scale parameter. So for example the exponential distribution with scale parameter β and probability density
could equivalently be written with rate parameter λ as
The normal distribution has two parameters: a location parameter and a scale parameter . In practice the normal distribution is often parameterized in terms of the squared scale , which corresponds to the variance of the distribution.
The gamma distribution is usually parameterized in terms of a scale parameter or its inverse.
Special cases of distributions where the scale parameter equals unity may be called "standard" under certain conditions. For example, if the location parameter equals zero and the scale parameter equals one, the normal distribution is known as the standard normal distribution, and the Cauchy distribution as the standard Cauchy distribution.
A statistic can be used to estimate a scale parameter so long as it:
Is location-invariant,
Scales linearly with the scale parameter, and
Converges as the sample size grows.
Various measures of statistical dispersion satisfy these.
In order to make the statistic a consistent estimator for the scale parameter, one must in general multiply the statistic by a constant scale factor. This scale factor is defined as the theoretical value of the value obtained by dividing the required scale parameter by the asymptotic value of the statistic. Note that the scale factor depends on the distribution in question.
where Φ−1 is the quantile function (inverse of the cumulative distribution function) for the standard normal distribution. (See MAD for details.)
That is, the MAD is not a consistent estimator for the standard deviation of a normal distribution, but 1.4826... MAD is a consistent estimator.
Similarly, the average absolute deviation needs to be multiplied by approximately 1.2533 to be a consistent estimator for standard deviation. Different factors would be required to estimate the standard deviation if the population did not follow a normal distribution.
Mood, A. M.; Graybill, F. A.; Boes, D. C. (1974). "VII.6.2 Scale invariance". Introduction to the theory of statistics (3rd ed.). New York: McGraw-Hill.